Click to Enlarge


FOUR ROLLS PLATE BENDING MACHINE MODEL M 3065 I
Technical data:
Installed power HP. 75
Rolls Table length mm 3,100/122″
Rolling capacity mm 65/2.56″
Pre-Bending Capacity mm 50/ 2″
Top roll diameter mm 630/ 24.8″
Lower rolls diameter mm 570 / 22.44″
Side rolls diameter mm 460 / 18.11″
Tilting of Side Rolls for cones Degrees max 2°
Bending Force Tons 860
Rolls C45
Hardening HRC 54-58
The max performances are referred to shells of diameter equal or larger than 3 times the top roll diameter and with material with a yield point within R = 260 N / mm².
Disclaimer: The information and specifications listed on this page are believed to be accurate, and are the responsibility of the company and or Individual representing the item being shown. Photographic representation are for illustrative pruposes only and may not be the actual machine and/or equuiptment being referred to. Steel Marketplace is not responsible for any typographical or errors that may exist.
Steel Marketplace © 2021 - All Rights Reserved. Terms and Conditions
Niagara Website Design by Future Access Inc.